PSoC™ Creator & Designer Forum Discussions
Hello,
I wanted to interface a 20-bit SAR ADC to the PSoC 5LP. I realized that the SPI_master block only allows 16-bit data transfers at a time before the SS line goes back high. Is there anyway I can do a 20-bit transfer without the SS line going high at 16-bits?
Show LessI installed the new PSoC Creator 4.3 on my Dell PC (Intel i7-9700). The software runs very slow. Does anyone have a solution?
Sincerly Andreas.
Show LessI am currently creating a project using the I2C slave component.
The transmission data is sent from the master side. How should the slave device read the set address?
I would like to prepare multiple set addresses, enter different numbers for each, and send them when selected by the master.
現在、I2Cのスレーブコンポーネントを使用し、プロジェクトを作成しています。
マスター側から送信データが送られますが、セットアドレスをスレーブデバイスはどう読み取ればいいのでしょうか。
セットアドレスを複数用意して、それぞれに別の数値を入れて、マスターから選択された際に、送信できるようにしたいです。
Show LessHi,
I want to transfer data from a mbed device to a psoc device over xbeedm. I belive the best way will be either xml or json.
Does anyone have any experience, or libraries to do this in psoc creator 4.3?
If there is a better solution please educate me!
Thanks
Rob Berry
Show LessI use these constantly...
CTRL + I: Corrects indentation
CTRL + /: Comment/Uncomment
CTRL + V: Paste
CTRL + C: Copy
CTRL + X: Cut
CTRL + Z: Undo
None of these work...
I am back to VI editing...
Help!
Show Lessdon not have CY8C6245AZI-D62?
Hi,
I need to use Keil/MDK to do further development for some reason. And I need the 8080 Interface in my application.
I download the code example CE223726 in Creator, and try to Generate CMSIS-Pack by build setting per the KBA/AN. But it will return failed as below.
How can I export this code example to Keil/MDK IDE?
Regards,
Ray
Show LessHello,
I am writing firmware for a collection of MCU's that network via CAN. As a result, there is a lot of redundant code used between the projects. (i.e, I use a CANUtility.c file to handle all CAN operations. All projects use CANUtility.c the same way, so if I have to make a change, i have to go to all projects and change its CANUtility.c). To combat this, I thought I'd might make a project library that all projects can include. However I seem unsure on how to do this. It does not recognize certain data types (like uint16, uint8) as i have to include project.h which is not there. In addition, I am unable to reference hardware, such as Pin_1_Read(). Is there a way I can have a file included in each project so that I have to make a change once? I've looked at the tutorials but was unable to do this.
Thank you
Show LessWhen using the AMuxSeq component in muxtype "single mode", the API does not generate a next function to handle the mux channels.
How to switch the channels otherwise?
Show Less