PSoC™ Creator & Designer Forum Discussions

Hello everyone

I'm a new user of Psoc Creator 3.3, I'm trying to get the parasitic capacitance value of Cap Sense V2.30. In the datasheet I found that we could use a BIST API called  CapSense_GetSensorCp(), however, it doesn't work when I called this API in main, I took a screenshot of both datasheet and the error information.

Anyone knows about these APIs ?

Thanks a lot.

Since a short time my PSoC Creator does not start with the project I worked on. It opens in a small window and not with full screen as I left it when closing the last session.  The list with the recent projects is empty.

I can find my project in   "open existing project" and it will open, but until last week I was used to find the project in a list of recent project and when clicking on it it opened as I left it, when closing the last session.

Is there a path missing or does the Creator not fínd the directory where it stored the settings?

Bert

Hello,

I am looking for an example project that provides at least a basic idea of how to pass data between the USBFS configured for a typical audio device (speaker and microphone) and the I2S component.  The project I am working on has an outboard CODEC (PCM3060) for processing the digital audio data.  The interface between the I2S component and the CODEC is working.  What I am looking for is an example of DMA processing between the USBFS and I2S components.  But at this stage of development a non DMA method is fine also.

Regards,

Ron

Our project uses a PSoC 5... we currently have it running using an SD card in SPI mode.  We really need

to access the card in SD/MMC mode in order to execute vendor-unique commands on the card... this cannot

be done in SPI mode.  Has anyone done this before?  Also, is there a way to browse Community-created

components without reading every post on the forum?

Hi,

I have trouble finding how to either manually import-export some text-file format and/or programmatically set/get the pin config in a PSoC Creator project.

Two use-cases:

 - To support several board-designs running the same software, easily be able to maintaing several pin-configuration mappings (kind of like a device-tree on linux)

 - When doing PCB Sch&Layout, during pin-swapping, I want to be able to push the netlist back & forth to PSoC Creator to check that it's a viable pin-swap. This is very tedious to do manually by entering the pins in the window shown below.

Thanks David