Attachments are accessible only for community members.
Aug 11, 2015
08:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 11, 2015
08:54 PM
Hi, is there any way to change the "Desired Frequency" of the WS2812 component?, i'm using the component on a design with the 5LP P.K., fist @ 24 MHz and it runs very good, but if i change my design to run @ 48 MHz the led's are all white.
Checking other designs (at the left on the image attached) with the same component the "Desired Frequency" is setup @ 48 MHz, i'm unable to find the way to change that parameter and i'm afraid that is what i'm missing to make it work well.
19 Replies