- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
I've got a question regarding the use of a CDC USB-I2C bridge with the Bootloader Host included with Creator.
Specifically, I'm using a CY7C65211-A configured for CDC I2C mode.
Bootloader Host sees this as a COM port, but a UART interface rather than I2C.
According to a thread I made a while back (AN60317: I2C Bootloader supported USB to I2C ports? ) I should be able to use this part for this purpose?
Might anyone know how to get Bootloader Host to see this device as a I2C bridge rather than a UART?
Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer to post number 3 in AN60317: I2C Bootloader supported USB to I2C ports?
That is what we meant over here.
I think post #5 was meant for an UART CDC device i.e UART CDC device will be supported by the Bootloader application.
Regards,
Hemanth