cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC Creator & Designer Software

Anonymous
Not applicable

Neither a usb cable plugged into the pioneer board or a cy8ckit-049-42xx board plugged directly  into the usb port will connect.  I get usb power to the device.  I hear audio feedback when they are plugged into the usb port but the device manager does not show any cypress device plugged in.  

   

I have de-installed/re-installed the USB-to-UART bridge.  I have removed the entire Cypress packages and re-install them, including the USB-to-UART bridge with the problem persisting.  I plugged in other USB-to-UART microprocessors (st.com Nucleo board and micro-bit) and they work and do download new code to the microprocessors.

   

Last weekend I received an automatic Windows 10 update that required a reboot.  Prior to that event I was able to program and debug PSOC devices.  When I use PSOC creator to download code there are No devices listed.  

0 Likes
Reply
1 Solution
Employee


Can you please download the USB-Serial Windows Driver Installer from the link:http://www.cypress.com/documentation/software-and-drivers/usb-serial-software-development-kit and install the drivers. Then plug the device
 

View solution in original post

0 Likes
Reply
1 Reply
Employee


Can you please download the USB-Serial Windows Driver Installer from the link:http://www.cypress.com/documentation/software-and-drivers/usb-serial-software-development-kit and install the drivers. Then plug the device
 

View solution in original post

0 Likes
Reply