Aug 05, 2020
01:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 05, 2020
01:47 PM
After disabling a pin, I got this error:
The Power on Reset (POR) setting for each Port must match between the Bootloadable (Application) and corresponding Bootloader projects. Port '1' has values 'Pulled Up' and 'Hi-Z Analog Unbuffered' between the projects respectively.
But all of the remaining pins in the Bootloadable are set to "Don't Care". If I set one of the existing pins to Hi-Z, the error goes away. If all the Bootloadable pins are set to Don't Care, then it shouldn't cause an error, it should just use the value that's set in the Bootloader.
Labels
- Labels:
-
PSoC Creator Software
4 Replies