- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have several devices that share the exact same source code and generated files, all of them use CAN communication with full CAN mailboxes and specific IDs (TX and RX), differing only in their ID numbers. Is there a way to set the IDs from code while maintaining the rest of the CAN configuration (mailboxes names, identifiers, etc) intact? This would help me program each one using only one project, by changing a flag or some other configuration file, instead of having to create a whole project for every device.
Best Regards,
Rodrigo
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Rodrigo,
Pls refer to Control Area Network (CAN) Protocol Troubleshooting Guide for PSoC® - KBA224456 (FAQs)
Thanks,
Shanmathi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Rodrigo,
Pls refer to Control Area Network (CAN) Protocol Troubleshooting Guide for PSoC® - KBA224456 (FAQs)
Thanks,
Shanmathi