Anonymous
Not applicable
Jul 03, 2012
06:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 03, 2012
06:04 PM
How I can change state (0 to 1), a pin on PSoC Creator?
I'm trying to make an application for an SPI master in a PSoC5 using the component provided by PSoC Creator. The device that I'm using as SPI slave, is a chip of reference ADS1298 from TI.
To complete the implementation of SPI communication, between PSoC5 and ADS1298, I need to put 3 pins that correspond to outputs digitals in PSoC Creator. The pins are: "Power_Down", "Reset" and "Start", these pins are normally 0, but after some delays programmed for each of them must change state to 1. How do I do it?
Hope you can help me, is urgent...
Thank you very much
Solved! Go to Solution.
1 Solution
Jul 04, 2012
01:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 04, 2012
01:30 AM
You can connect your pins to a timer component. This allows you to change them automatically after a certain delay.
5 Replies