Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Hi, Just Setting up CY8CKIT042BLEKIT, and I am getting the following PSoC Programmer error (Cut & past): ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ | KitProg Version 2.10 Firmware Update Finished at 2:34:59 PM | | FAILED! Failed at BlockID = 40 SubPkt = 0 Msg = The data is not of the proper form.. Please replug KitProg. | Upgrading... | Initializing... Firmware Upgrade Started at 2:34:48 PM | Firmware Upgrade Requested at 2:34:48 PM | | Please navigate to the Utilities tab and click the Upgrade Firmware button Port Opened with Warnings at 2:33:28 PM | KitProg version Expecting 2.14, but found 2.10. Opening Port at 2:33:27 PM | Device set to CY7C65215-32LTXI at 2:33:27 PM 32768 FLASH bytes Device Family set to CY7C65210 at 2:33:27 PM | Active HEX file set at 2:33:26 PM | | | Users must be aware that the following PSoC device should not be powered or programmed at 5V. Doing so will cause damage to the device: CYRF89xxx Session Started at 2:33:26 PM | PPCOM Version 20.0 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Everything has been updated. CySmart and initial H/W demo works. Thanks! Bob