cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC Creator & Designer Software

EsFr_4600111
New Contributor II

Using Psoc creater 4.2 for BLE development.

I have been going through some of the turtorials, but some of them use the logic components (AND,OR NOT etc.) But theese components are not avilble in my setup, how can i enable theese ?

Capture.PNG

0 Likes
1 Solution
Rakshith
Moderator
Moderator

Hi EsFr_4600111,

Can you please share the screenshots of the above steps? I have shared the screenshots of my PC below for your reference -

1. pastedImage_0.png

2. pastedImage_0.png

Also, can you please try the following -

1. Click on Components tab in Workspace Explorer.

pastedImage_1.png

2. Right click on your project and click on Import Component.

3. Select Import from project/library.

4. Select CyPrimitives in the drop down and then select and component as the source component as shown. Click on OK.

pastedImage_2.png

Hope this helps,

Thanks and Regards,

Rakshith M B

  

Thanks and Regards,
Rakshith M B

View solution in original post

0 Likes
3 Replies
Rakshith
Moderator
Moderator

Hi EsFr_4600111​,

It seems like your components are not updated. Can you please update your components list by these steps -

1. Tools-->Find New Components and Find New Devices to upgrade the Creator to latest status.

2. Follow the steps mentioned in this KBA - Updating PSoC Creator Components

Hope this helps,

Regards,

Rakshith M B

Thanks and Regards,
Rakshith M B
0 Likes
EsFr_4600111
New Contributor II

Hi Rakshith

This did'nt solve my issue. 😞

Still can't see the eg Not function in Digital->  Logic folder

Br

Esben

0 Likes
Rakshith
Moderator
Moderator

Hi EsFr_4600111,

Can you please share the screenshots of the above steps? I have shared the screenshots of my PC below for your reference -

1. pastedImage_0.png

2. pastedImage_0.png

Also, can you please try the following -

1. Click on Components tab in Workspace Explorer.

pastedImage_1.png

2. Right click on your project and click on Import Component.

3. Select Import from project/library.

4. Select CyPrimitives in the drop down and then select and component as the source component as shown. Click on OK.

pastedImage_2.png

Hope this helps,

Thanks and Regards,

Rakshith M B

  

Thanks and Regards,
Rakshith M B

View solution in original post

0 Likes