Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
In the component datasheet there is this at beginning -
Level – IRQ source is sticky and remains active until firmware clears the source of the request with an action (for example, clear on read). Most fixed-function peripherals have level-sensitive interrupts, including the UDB FIFOs and status registers.
In the application note AN54460 a much better description -
LEVEL: This option routes the interrupt source through the direct path in the DSI interface, as Figure 9 on page 6 shows. Select this option for interrupt sources that you want to be level-triggered, for example UDB-based Components such as UART, SPI, timer, counter, and PWM.
Note Select only the LEVEL option for interrupts generated by UDB-based components such as UART and SPI. The reason is that these components generate a level interrupt to indicate the UDB FIFO buffer status signal. The FIFO buffer, which is 4 bytes deep, is used to temporarily store data to be transmitted (Tx FIFO) or received (Rx FIFO).
I think datasheet should reflect the content of both, eg. sticky and the components that have to have a LEVEL
setting. Further a complete table of what components can use what interrupt settings.
Ideally Creator should flag when a user connects isr component to another component that
wants a LEVEL configured isr. No shortage of confusion over this.
Lastly one of the selections is DERIVED. Call me stupid but this leads me to always believe that
tool was smart enough to assign the right default for the component source for the isr. That is the
way it is described. Of course nothing could be further from the truth. So the word "DERIVED"
seems inadequately described in the isr component datasheet and above referenced ap note.