cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC Creator & Designer Software

LePr_1339861
New Contributor

Following CE220263, I believe I have set up everything correctly. I just want to do Cy_GPIO_Write or Cy_GPIO_Set/Cy_GPIO_Clr. The code builds with no errors or warnings, but the pins do not move. Is there any instruction or sample for this simple implementation? I am under the gun to deliver.

0 Likes
Reply
1 Solution
MotooTanaka
Esteemed Contributor

Hi,

I assume that you are using CY8CKIT-062-BLE for that CE, correct?

With CY8CKIT-062-BLE, according to the Kit Revision(s) there are some limitations/requirements.

000-PSoC6_BLE_PDL.JPG

https://www.cypress.com/documentation/development-kitsboards/psoc-6-ble-pioneer-kit-cy8ckit-062-ble

You can check the PDL version from the PSoC Creator Menu Project > Build Settings...

In the Build Settings Dialog, select Peripheral Driver Library

Then you can see what PDL version is set for your environment. (My case it's 3.1.2)

You can change the default version from the Menu Tools > Options

or just select "Custom" and specify an appropriate PDL version installed in your system.

001-Build-Settings.JPG

To download other version(s) of PDL, go to

https://www.cypress.com/design-guides/peripheral-driver-library-pdl-psoc-creator

Just in case, if I'm totally missing the point. I'm sorry.

moto

View solution in original post

0 Likes
Reply
2 Replies
MotooTanaka
Esteemed Contributor

Hi,

I assume that you are using CY8CKIT-062-BLE for that CE, correct?

With CY8CKIT-062-BLE, according to the Kit Revision(s) there are some limitations/requirements.

000-PSoC6_BLE_PDL.JPG

https://www.cypress.com/documentation/development-kitsboards/psoc-6-ble-pioneer-kit-cy8ckit-062-ble

You can check the PDL version from the PSoC Creator Menu Project > Build Settings...

In the Build Settings Dialog, select Peripheral Driver Library

Then you can see what PDL version is set for your environment. (My case it's 3.1.2)

You can change the default version from the Menu Tools > Options

or just select "Custom" and specify an appropriate PDL version installed in your system.

001-Build-Settings.JPG

To download other version(s) of PDL, go to

https://www.cypress.com/design-guides/peripheral-driver-library-pdl-psoc-creator

Just in case, if I'm totally missing the point. I'm sorry.

moto

View solution in original post

0 Likes
Reply
LePr_1339861
New Contributor

Thanks much, your info helps me going forward. I also found a couple issues in my code. I now am able to control the pins fine.