- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The mode command doesn't work. I get 'Command format error!!'
It doesn't matter if I'm trying to query the mode or set it. I'm trying to get these devices recognized by an industrial gateway that unfortunately only recognizes Eddystone mode (et al). It does not seem to recognize BLE beacon mode as it's specifically looking for a MAC address.
Solved! Go to Solution.
- Labels:
-
PSoC general
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
To use eddystone mode, the firmware needs to update to Version 1.2.00. Please refer to '4.2.3 Programming Using PsoC Programmer' section in the kitguide datasheet.
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
To use eddystone mode, the firmware needs to update to Version 1.2.00. Please refer to '4.2.3 Programming Using PsoC Programmer' section in the kitguide datasheet.
Thanks,
P Yugandhar.