- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to create a UDB element with the UDB Editor, but I can't figure out how to bring P0 and P1 in and out. I don't see how that is done and those ports don't show up on the component symbol.
I looked through the UDB Editor Guide and poked around in the Editor, but couldn't find anything.
Has someone else figured out how that works?
thanks,
Doug
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you seen this (project 5) -
http://www.cypress.com/?rID=69774 AN82156 - PSoC® 3, PSoC 4, and PSoC 5LP - Designing PSoC Creator™ Components with UDB Datapaths
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
the parallel adder example in that doc may be just what i need.
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hope that helps, if not you can file a CASE unless some one else
can comment.
To create a technical or issue case at Cypress -
“Support”
“Technical Support”
“Create a Case”
You have to be registered on Cypress web site first.
Regards, Dana.