I am Using the Controller CY8C29466-24SXI . In that Just Configuring the Port Pin to Turn ON And OFF the LED . But Controller Not responding its Points to Always HIGH State .
Source Code :
PRT2DR = 0;
VLT_CR = VLT_CR_4V5_POR;
PRT1DR = 0x00;
PRT0DR = 0;
PRT2DR = 0;
Note : PORT Pins were Configured as Respective Global Out
Kindly Help me if I Miss anything on the Global resource Configurations Parameters
Solved! Go to Solution.
Thanks for the Comments . Yes Changed the Drive Mode and Working Fine With that . Before Using the Global Resource Out Pin For Configuration of Port Pins .
Can You Guide me how to enable Debugging Option by Using the Mini Programmer / Debugger in the code attached Code for your Reference
Hi @Praba ,
MiniProg and MiniProg3 cannot be used to debug PSoC1 devices. MiniProg3 supports debugging of PSoC3/4/5 devices.
Having said that, PSoC1 is a very mature product family, and there is little support for the same. Request you to kindly consider PSoC4 for new designs.
Thanks for the Reply . I am using the PSOC5 . The thing PSOC1 for my old Project Support . So Requested if its Possible for PSOC1 .
Kindly Provide me the Solution - How to Enable Debugging Option in PSOC Creator 4.2 .