cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC Creator & Designer Software

MoOu_4768141
New Contributor

Hello,

I´m trying to flash an hex file into  "CY8CKIT-149 PSoC" Board.

Using PSOC Creator I get the following (empty window)

:

using PSOC Programmer:

Can you please provide some hints how to solve that?

Thanks in advance.

0 Likes
1 Solution
DheerajK_81
Moderator
Moderator

Please make sure that PSoC Programmer is not connected to your device in the background when using PSoC Creator. Close it and then see if the device is seen in PSoC Creator. Check if the switch SW4 is towards one of the extremes and not hanging somewhere in between.

Refer the Troubleshooting Guide to see if it helps solve your problem.

Regards,

Dheeraj

View solution in original post

0 Likes
5 Replies
DheerajK_81
Moderator
Moderator

I think the images didn't get added. Can you please reattach the screenshots?

Regards,
Dheeraj

0 Likes
MoOu_4768141
New Contributor

Please find the screenshots attached:

1.JPG22.JPG

0 Likes
DheerajK_81
Moderator
Moderator

Please make sure that PSoC Programmer is not connected to your device in the background when using PSoC Creator. Close it and then see if the device is seen in PSoC Creator. Check if the switch SW4 is towards one of the extremes and not hanging somewhere in between.

Refer the Troubleshooting Guide to see if it helps solve your problem.

Regards,

Dheeraj

View solution in original post

0 Likes
MoOu_4768141
New Contributor

I laready closed both applications. I tried with PSOC Programmer and got the same problem. I closed the PSOC Programmer and started PSOC Creator and I get same problem.

Regards

0 Likes
MoOu_4768141
New Contributor

sorry I was mixing SW3 and 4. SW4 was not in the right position.

0 Likes