Attachments are accessible only for community members.
Anonymous
Not applicable
Mar 18, 2013
11:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 18, 2013
11:32 AM
When using the datapath configuration tool, it is important to set up the signal chaining properly in order to get the proper behavior. This memo provides a simple sheet that shows the datapath chaining configurations for datapaths of 16, 24 and 32 bit widths. It also shows the proper configurations for shift left, shift right and arithmetic shift right.
4 Replies
Mar 18, 2013
04:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 18, 2013
04:01 PM
That is a cool logo you got there
Anonymous
Not applicable
Mar 18, 2013
04:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 18, 2013
04:07 PM
Lol! thanks : )
Anonymous
Not applicable
Apr 05, 2013
12:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 05, 2013
12:17 PM
You guys also may be interested in the 'Datapath Configuration Tool Cheat Sheet' KB Article available here: http://www.cypress.com/?id=4&rID=77887
It incorporates Chris' chaining cheat sheet.
Anonymous
Not applicable
May 05, 2013
05:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 05, 2013
05:36 PM
Got both. Start learning to use the DP. May be able to use it the next project.