PSoC Creator & Designer Software

[DaEd_3032071]

I have an old CY8CKIT-050 kit that I can program with the PSoC Creator 1.0, but when I use 4.2 or 4.3 I get this error:

This device was recognized, but PSoC Creator does not support using it at this time.

[MotooTanaka]

Hi,

Please try to down load the newest PSoC Programmer from the URL below.

And try again after installing the new PSoC Programmer, if there is any improvement.

https://www.cypress.com/documentation/software-and-drivers/psoc-programmer-archive

moto

[NoriakiT_91 · Accepted solution]

Do you mean the first version of PSoC 5 DVK board?

If so,

PSoC 5 was replaced with PSoC 5LP and will not be supported recent PSoC Creator.

Please refer following link to upgrade your kit with a new DVK.

https://www.cypress.com/products/psoc-5

Regards,

Noriaki

[DaEd_3032071]

Yes, I have the PSoC 5 DVK, not the 5LP.  Interesting.  So I am stuck with using PSoC Creator 1.0?  Can I get either 2.x or 3.x to see if either of those will program it? 

Can I use the latest PSoC creator and then use the 1.0 PSoC Programmer?

In order to upgrade, do I get a new DVK or just the PSoC Device?

[NoriakiT_91]

Please refer the "Migrate to PSoC 5LP" tab at that page or click following link.

https://www.cypress.com/products/psoc-5#tabs-0-bottom_side-3

The kit had been upgraded for free at following link.

https://www.cypress.com/go/psockitupgrade

But, the upgrade program seems to be ended.

Regards,

Noriaki

[DaEd_3032071]

Unfortunately, the the free kit upgrade period has ended.  I have a support case opened as well.  Maybe they can provide me with a replacement.

Thanks for your help.