- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there any command line interface software for programming CapSense CY8CMBR3 by using Miniprog3 or USB/I2C cable? Thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I did try Psoc programmer, but seems it does not support CapSense CY8CMBR3.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Victor,
MBR3 devices are preprogrammed and cannot be re-programmed.
You can configure the MBR3 devices using I2C.
Please refer the design guide: http://www.cypress.com/file/46366/download [Section '5. Configuring CY8CMBR3xxx']
Thanks
JOBIN GT
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there any command line interface software for configuring CapSense CY8CMBR3 by using Miniprog3 or USB/I2C cable? Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
EZ-Click is the recommended software. Never seen a comand line interface software for this.
http://www.cypress.com/documentation/software-and-drivers/ez-click-20
Thanks
JOBIN