PSoC™ 6 Forum Discussions
I own Rev11 of PSoC6 BLE PIONEER KIT.
What kind of support can I get?
Hi
I need to write 2 pieces of data, each is 5-bits.
The first is written to port-9 pins 0 to 4 (P9.0, P9.1, P9.2, P9.3, P9.4). This is done using GPIO_PRT_OUT()
The second is written to P9.5, P9.6, P5.4, P5.5, P5.6. What is an efficient method to split the second data word (5-bits) among bits in 2 ports ?
Thanks
Show Less
Hello,
I have another problem with getting the RTC running from a backup battery. I checked the current consumption of the backup supply and it seems like the Pins of port 0 are feeding a current into the attched electronics. Furthermore it seems like the output voltages of these pins are limited to my battery voltage, yet they are not supplied by the battery but by the switchover to VDDD. Is there any additional documentation on this?
best regards,
Christian
Show LessI am new bee, exploring PSOC on eclipse and VS code.
Struggling to find a proper document for learning freeRTOS. Some body could you please help me
Show Less我使用的芯片是CY8C624AAZI-S2D44 ,调用emusb-device 的USBD_Start() 提示错误如下,官方例程是运行好的,我自己新建工程按照emusb-device/release-v1.2.0/docs/html/index.html#section_emusb_device_quick_start,一步一步操作 就出现这个错误
Show Less
My projects develop with POSC62 MCU,as UDB module is the important part of requirement,so i selected psoc creator IDE for my project development. But now, because of the need for expansion,I have to use machine learning module.
您好 请教下 CY8CKIT-062S2-43012的开发板Modustoobox的程序如何修改sdio速率为1Mhz或者2Mhzh
Hello
I need to write 4 bits to port9 (pins P9.0 to P9.3) as one data of type uint8_t.
Is there a way to do this in one step, as the other ways I know is writing to each individual pin.
Thanks
Show LessHi sir,
I am working on psoc6 . It is supporting i2c multi master. First I am configured in slave mode and master send to data to slave by using cyhal_i2c_master_write(). and I am trying read data from slave by using slave function cyhal_i2c_slave_read(). During debugging time I am getting timeout error. How to solve this issues ? how to configure properly?
Show Less