- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am about half way through a project and I would like to see how much RAM and FLASH (for code) has been used up. In most other IDEs I can find this information in the map file produced by the linker. But so far I haven't been able to find this in the map file created by Creator 4.3 or anywhere else in the reports, tabs, etc. that are available.
Can anyone point out to me where I can find this information?
Thanks,
Ed H.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ed,
If you are able to successfully build the project as it currently stands, then do the following:
- Perform a "Clean and Build".
- The Output window should report NO errors preventing the build and the bottom of the output window should list:
code:412168 sram:35748
--------------- Build Succeeded: 04/29/2020 22:18:08 ---------------
code: = FLASH allocated and sram = RAM used.
Is this what you are looking for?
Len
"Engineering is an Art. The Art of Compromise."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ed,
If you are able to successfully build the project as it currently stands, then do the following:
- Perform a "Clean and Build".
- The Output window should report NO errors preventing the build and the bottom of the output window should list:
code:412168 sram:35748
--------------- Build Succeeded: 04/29/2020 22:18:08 ---------------
code: = FLASH allocated and sram = RAM used.
Is this what you are looking for?
Len
"Engineering is an Art. The Art of Compromise."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yep! Sure enough, there it is. 🙂