I have the PSoC 6 BLE Pioneer Kit which doesn't seem to work.
I tried to upload several example projects without success. If I try to program something on my own (just a LED blinking) it works.
Currently I am trying to use the Eink capsense example project. With debugging I found out that on startup the device doesn't initialise.
When I got to line 198 in cyfitter_cfg.c - Cy_SysClk_ClkTimerSetSource(CY_SYSCLK_CLKTIMER_IN_IMO); it goes to Fault_Handler (startup_psoc63_cm0plus.s line 347) and on line 350 - tst r0, r1 it opens Disassembly and from then on I am lost.
What to do to make this (and other) example work?
Solved! Go to Solution.
I tried the example and also reinstalled the IDE (just to be sure) and it doesn't work.
The example did manage to light up the LED in green but I couldn't connect to it via bluetooth.
CY8CKIT-062-BLE Rev *B
I forgot to mention that the device came with a preloaded example and that was working. The problems started when I tried to upload a example project (I followed the provided instructions).
It doesn't work. So there is probably a hardware problem?
I'm not sure how this happened since the first thing I tried to upload was an example project (the same one that you just send),and since then it doesn't work.
I've attached a hex file of the same project with an additional feature that can be used to view debug messages through UART using a serial port terminal emulator such as Tera Term. After programming PSoC 6 MCU with the attached hex file, you should set up a serial port terminal emulator with these settings to view the debug information:
• Baud rate : 115200
• Data size : 8-bit
• Parity : None
• Stop : 1-bit
• Flow Control : None
Reset to view the debug information:
Please copy / paste this information to a post so that we can figure out which block is failing.
It doesn't seem to work. I get no output.
As I said in the first post, I don't think the MCU even initialises so no user code is executed.