- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am testing my new PSoC 6 Wi-Fi BT Prototyping Kit (CY8CPROTO-062-4343W) with an example project (as well as blank empty project), and it does not allow me to program the board with the message: "Port Acquire Failed - Can't open CMSIS-DAP port".
It also says, "This device was recognized, but Psoc Creator doesn't support using it at this time"
PSoC Creator 4.4
PSoC Programmer 3.29.0
CMSIS-DAP Version 2.0.0
Firmware Version 2.10.878
Please support! Thanks!
Solved! Go to Solution.
- Labels:
-
ispn:40047:1:0
-
l1:314:1:0
-
PSoC6MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CYPROTO-062-4343W contains the CY8C642ABZI-S2D44 part that is currently not supported by PSoC Creator.
You need to use Modustoolbox in order to program the CYPROTO-062-4343W kit.
Thanks and Regards
Ekta
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CYPROTO-062-4343W contains the CY8C642ABZI-S2D44 part that is currently not supported by PSoC Creator.
You need to use Modustoolbox in order to program the CYPROTO-062-4343W kit.
Thanks and Regards
Ekta