PSoC 6 PDM sinc rate question

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
euggersh
Level 5
Level 5
5 sign-ins First solution authored 50 replies posted

The PDM component sinc rate can be set from 0 to 127.  Does the actual hardware use the raw value or does it add 1 to it?

If raw value, 0 seems like an invalid configuration, but the component configuration dialog allows it.  That also means that the very handy power-of-two value of 128 is not available.

0 Likes
1 Solution
Vasanth
Moderator
Moderator
Moderator
250 sign-ins 500 solutions authored First question asked

Hello Eugene,

Apologies for the delay. The sinc rate of the component can take values from 1-127. It takes the raw value, and it do not add 1 to it. So the value 128 is not available in the component. We will take necessary steps to remove 0 from the permissible values.

Best Regards,
Vasanth

View solution in original post

0 Likes
3 Replies
euggersh
Level 5
Level 5
5 sign-ins First solution authored 50 replies posted

When Cypress eliminated real support and moved everything to the forum, I was under the impression that Cypress employees would be responding to posts on here.  Is that not actually the case and there's no support left at all?

kendallc_96​ maybe?

0 Likes
Vasanth
Moderator
Moderator
Moderator
250 sign-ins 500 solutions authored First question asked

Hello Eugene,

Apologies for the delay. The sinc rate of the component can take values from 1-127. It takes the raw value, and it do not add 1 to it. So the value 128 is not available in the component. We will take necessary steps to remove 0 from the permissible values.

Best Regards,
Vasanth

0 Likes