cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 6 MCU

EuGe_296116
Contributor II

The PDM component sinc rate can be set from 0 to 127.  Does the actual hardware use the raw value or does it add 1 to it?

If raw value, 0 seems like an invalid configuration, but the component configuration dialog allows it.  That also means that the very handy power-of-two value of 128 is not available.

0 Likes
1 Solution
Vasanth
Moderator
Moderator

Hello Eugene,

Apologies for the delay. The sinc rate of the component can take values from 1-127. It takes the raw value, and it do not add 1 to it. So the value 128 is not available in the component. We will take necessary steps to remove 0 from the permissible values.

Best Regards,
Vasanth

View solution in original post

0 Likes
3 Replies
EuGe_296116
Contributor II

When Cypress eliminated real support and moved everything to the forum, I was under the impression that Cypress employees would be responding to posts on here.  Is that not actually the case and there's no support left at all?

EuGe_296116
Contributor II

kendallc_96​ maybe?

0 Likes
Vasanth
Moderator
Moderator

Hello Eugene,

Apologies for the delay. The sinc rate of the component can take values from 1-127. It takes the raw value, and it do not add 1 to it. So the value 128 is not available in the component. We will take necessary steps to remove 0 from the permissible values.

Best Regards,
Vasanth

View solution in original post

0 Likes
Top labels