- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I was following PSoC 6 101 tutorial from YouTube. I have created pripheral device with custom led service and central device. I have two PSoC 6 kits. However, when I scaned available devices and printed them to Putty, I was expecting that connection between central and peripheral to be established. The only thing that I observed is central printed device address of my peripheral but it could not connect it.
I am sharing source codes both central and peripheral. Could you help me with this issue? Where did I make a mistake?
Source Codes:
Cypress_Community - Google Drive
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please check the attached project also. In this project the BLE acts as a UART bridge between two PSoC 6 BLE devices.
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Sure. We will check your project code. Meanwhile could you please check the PSoC 6 BLE throughput code example where there will be two projects one as central and other as peripheral. You can use the same firmware flow as used in the code example:
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content