- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm using MiniProg4 with the PSoC Programmer (API) to program PSoC6. Turns out Miniprog3 is MUCH faster. Checked this with a hex file which takes 20 seconds to program on a MiniProg4 and only 6 seconds on a MiniProg3.
It seems the difference in speed is related to the fact that Miniprog3 has a FX2 & a dedicated FPGA for programming, while Miniprog4 uses a PSoC5.
Any chance to enhance speed on the Miniprog4?
Regards,
Rolf
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Miniprog4 doesn't support USB high speed, it uses the PSoC5LP which has only USB full-speed support. Please let me know the firmware version running on your MiniProg4 by using the fw-loader tool. Download the latest version from here.
Open it up in a command prompt and run "--device-list" as shown below:
The FW Version will be listed. Please update KP3 to the latest one using the command "--update-kp3" as shown below:
The newer versions of KP3 should be ~1.5 times faster than the older versions. Let me know your observations.
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Miniprog4 doesn't support USB high speed, it uses the PSoC5LP which has only USB full-speed support. Please let me know the firmware version running on your MiniProg4 by using the fw-loader tool. Download the latest version from here.
Open it up in a command prompt and run "--device-list" as shown below:
The FW Version will be listed. Please update KP3 to the latest one using the command "--update-kp3" as shown below:
The newer versions of KP3 should be ~1.5 times faster than the older versions. Let me know your observations.
Regards,
Dheeraj