- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Greetings from India fellow developers !
i have one Dynamixel servo(ax12-a) and a Psoc6 CY8CKIT-062-WIFI-BT looking for ways to interface the Dynamixel servo with psoc 6 . it would be great if someone can guide me on how to do it with or without additional hardware.also it would be enough if someone can show me where to start.
thanks in advance!
Regards,
Pallav Karya
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Pallav,
I am assuming that you are starting from ground zero. Let us start with the electrical/physical connections. Please see the attached block diagram for starters and please double check the details as I could have made mistakes this late my time. Especially because I do not have a servo so I cannot verify the specifications provided by the servo manufacturer website i.e. pin out and connector pins order etc... Trust but verify.
Please note: Do not power your kit from the LiPo 11.1V battery unless you know that you can. I have not checked if it provides regulated input anywhere. In this setup I am assuming your kit will be powered through its own supply source such as USB or other arrangements you have made.
.
Best Regards,
Wess
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Pallav,
I am assuming that you are starting from ground zero. Let us start with the electrical/physical connections. Please see the attached block diagram for starters and please double check the details as I could have made mistakes this late my time. Especially because I do not have a servo so I cannot verify the specifications provided by the servo manufacturer website i.e. pin out and connector pins order etc... Trust but verify.
Please note: Do not power your kit from the LiPo 11.1V battery unless you know that you can. I have not checked if it provides regulated input anywhere. In this setup I am assuming your kit will be powered through its own supply source such as USB or other arrangements you have made.
.
Best Regards,
Wess
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thankyou for your invaluable time and effort we really appreciate that.
this got me started thanks again.