- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Post you project -
"File"
"Archive Project"
Use Internet Explorer or Firefox to upload project. Then Forum can try to help.
Also write both english and your native language in your post, we will
use Google Translate, as well as reading your English, to try to under-
stand your questions.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you are using CY3217 (Miniprog1), you can either power the project
from the programmer menu after you program part, or remove
Miniprog1after programming and power from external power supply/battery.
If you power project from Miniprog1 the Miniprog1 can only supply
as much power as the USB port can provide. USB 1.0 150 mA, 2.0
500 mA.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Some thoughts -
1) Make sure your USB driver on PC is up to date. This normally
is done by updating chip set driver.
2) If your board draws a lot of power disconnect high power loads
when programming, or use an external 3'rd party board, like dip board
as an example.
3) Take a look at this ap note and its references -
http://www.cypress.com/?rID=2726 AN2014
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Seems to me you are seeking a bootloader like operation.
You first program PSOC not using miniprog, then you want miniprog
to do additional programming. This is bootloader like operation, where
a kernal pre-loaded into PSOC directs further programming operation,
in this case from a miniprog.
Take a look at these to see if they may accomplish, with your modification, possibilities -
http://www.psocdeveloper.com/forums/viewtopic.php?f=3&t=5658
http://www.cypress.com/?id=4&rID=60862
Otherwise I simply do not understand your question.
Regards, Dana.