- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
so, I have a kit prog that I snapped off of a cy8ckit-059, and I want to use it to program the cy8ckit-010. the 010 only has a 2x5 pin, fine pitch, connector, and the kitprog has a single line header with, I think, serial wire debug pins. what's the best way to connect these? it seems like all of the pins I need for programming with the kitprog are Vtarg, gnd, SWDIO, SWDCK, and RST. looking at the datasheet, it looks like I can connect SWDIO to the TMS pin of the 010, and SWDCK to the TCK pin, and the others are obvious.
so, I guess I have two questions:
1) is there a cable or something that adapts the two? I would be fine with buying a little cable.
2) am I missing anything in trying to make this work? I don't want to put in a lot of work if Kitprog is not compatible with the 010 kit.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For your queries:
1) is there a cable or something that adapts the two? I would be fine with buying a little cable.
>>Presently, I can't find any recommended cable that connects 10pin SWD/JTAG to 5 pin SWD
2) am I missing anything in trying to make this work? I don't want to put in a lot of work if Kitprog is not compatible with the 010 kit.
>>Yes, it is compatible.Just make sure that length of cable is not more than 10-12 cm between the connectors.
I would recommend that you go through the Programming and Debug interfaces section of the application note AN61290- Hardware Starting Guide with PSoC® Creator available at www.cypress.com/
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For your queries:
1) is there a cable or something that adapts the two? I would be fine with buying a little cable.
>>Presently, I can't find any recommended cable that connects 10pin SWD/JTAG to 5 pin SWD
2) am I missing anything in trying to make this work? I don't want to put in a lot of work if Kitprog is not compatible with the 010 kit.
>>Yes, it is compatible.Just make sure that length of cable is not more than 10-12 cm between the connectors.
I would recommend that you go through the Programming and Debug interfaces section of the application note AN61290- Hardware Starting Guide with PSoC® Creator available at www.cypress.com/
Regards