These might be of assistance -
http://www.cypress.com/?rID=37793 AN52705 Getting Started with DMA
http://www.cypress.com/?rID=82680 AN84810 PSoC® 3 and PSoC 5LP Advanced DMA Topics
http://www.cypress.com/?rID=44335 AN61102 PSoC® 3 and PSoC 5LP - ADC Data Buffering Using DMA
http://video.cypress.com/video-library/search/dma/ Videos on DMA
https://www.youtube.com/results?search_query=dma+psoc Videos on DMA (some overlap)
LO16((uint32)DMX1_UART_TXDATA_PTR) is working for dma to uart tx. Thanks for the first reply. They should simply state this in the uart component data sheet rather than telling you to use the register as the dma target. I did read the dma app notes before starting, they were helpful showing how to set up the TDs but not for something specific like dma to uart. They should probably add more peripherals like uart to the dma wizard. Cypress documentation can be annoying at times but compared to others it's pretty good.
Hello friends, I need to communicate with a NEXTION smart screen, Using the PSOC 5LP UART. I have to show three variables on the screen and receive data as well. I want you to tell me which are the sentences that I should use since I am new using PSOC....Sorry for my english I am from Argentina....Thanks for your time
Welcome in the forum, although it is not a good idea to hijack a 3 year old thread with a completely new question.
It would have been better to create a new thread.
To your question: PSoC5 LP has got several UART interfaces using 3.3 to 5V I/O level, so interfacing will not be a problem.
Converting numbers to string could be done best using sprintf() library function. Cursor positioning depends on the commands your display understands, VT100 is a widely used command set.
To get sprintf() running you need to
Sorry for the kidnapping, I did not know how to create the new theme hahaha.
The screen has serial communication, is a touch screen, this screen is configured with a soft from the pc. Buttons, progress bars, or needles can be placed to indicate variations. Observe a communication type using UART_PutChar () and UART_GetChar () but only one bit was sent. And as I said I need to send three different values to the screen and receive the status of a button that you configure ... thank you very much for replying