Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
My problem is described below: once toggle power is activated the device is in " not powered " state (bottom right). see image On the device a green led (status) and a red led (target power) are both ON. Is it a faulty programmer? with the other programmer we have everything works properly. Do I need to reset it in some way or update the firmware? Thank you in advance
Looks like you have a faulty MiniProg3. It is not able to supply power to the target device, it shows the voltage detected to be only 800mV instead of 3.3V. This is the reason PSoC Programmer reports "Not Powered" as the status.
There is a LED at upper right corner that indicates if the MiniProg3 is supplying power to the target connectors. Do you see the red led light up?