Mar 13, 2011
12:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 13, 2011
12:19 PM
I was going to use Basic Design to learn about the Debugger. I loaded it and tried to do a build. The errors indicate that the (hardware?) is set to 5.5v on the Vddio0-3 pins (they were so I fixed the jumper pins on the -001 kit board) and I selected 3.3v with the slide switch. HOWEVER, I still get that set of errors when I do a clean and build for Basic Design.
What did I forget or miss?
Thanks
Tim M
Tim Miner
Labels
- Labels:
-
PSoC 3
3 Replies