Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I was going to use Basic Design to learn about the Debugger. I loaded it and tried to do a build. The errors indicate that the (hardware?) is set to 5.5v on the Vddio0-3 pins (they were so I fixed the jumper pins on the -001 kit board) and I selected 3.3v with the slide switch. HOWEVER, I still get that set of errors when I do a clean and build for Basic Design.
PSoC Datasheet says that VDDD and VDDIO should be less than VDDA. VDDA should always be higher than or equal to that of VDDD and VDDIO. PSoC Creator will generate error message to inform the user that VDDD and VDDIO is out of range. In such case user is supposed to set VDDD and VDDIO to a value less than that on VDDA.
Please note that this setting is the setting to be made in the project. It is not the jumper setting on your board. VDDA, VDDD and VDDIO voltages can be set under "project.cydwr --> System --> Voltage Configuration" as shown in picture below.