cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

Hi All,

Is there an example using multiple UARTS on one PSOC LP5 (CY85888LTI-LP097) ?

Attached is what I'm thinking of.

(I'm looking for an example so I can setup the ISRs correctly.)

Basically 2 PCs and 1 GPS receiver.

thanks,

Bob

ps I did a couple searches and could only find multiple uarts using multiple PSoCs.

0 Likes
Reply
1 Solution
Esteemed Contributor II

Your schematic looks allright. I would suggest you to increase the UART's buffers so that the internal handlers are used. Saves you from setting up your own interrupt handlers. You can check for data using UART_GetRxBufferSize() API (see datasheet) in your main-loop.

Bob

View solution in original post

0 Likes
Reply
2 Replies
Esteemed Contributor II

Your schematic looks allright. I would suggest you to increase the UART's buffers so that the internal handlers are used. Saves you from setting up your own interrupt handlers. You can check for data using UART_GetRxBufferSize() API (see datasheet) in your main-loop.

Bob

View solution in original post

0 Likes
Reply
Anonymous
Not applicable

thanks!

Bob

0 Likes
Reply