- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
Is there an example using multiple UARTS on one PSOC LP5 (CY85888LTI-LP097) ?
Attached is what I'm thinking of.
(I'm looking for an example so I can setup the ISRs correctly.)
Basically 2 PCs and 1 GPS receiver.
thanks,
Bob
ps I did a couple searches and could only find multiple uarts using multiple PSoCs.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your schematic looks allright. I would suggest you to increase the UART's buffers so that the internal handlers are used. Saves you from setting up your own interrupt handlers. You can check for data using UART_GetRxBufferSize() API (see datasheet) in your main-loop.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your schematic looks allright. I would suggest you to increase the UART's buffers so that the internal handlers are used. Saves you from setting up your own interrupt handlers. You can check for data using UART_GetRxBufferSize() API (see datasheet) in your main-loop.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thanks!
Bob