- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there source code for the firmware (hex file) that matches the loopback application located at
C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\application\c_sharp\bulkloop ?
When I try the bulkloop the connected device is visible but the endpoints are empty. The current
firmware hex file is an56377.
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can check the Project1 of AN56377 depicting the loopback at interrupt, bulk, and isochronous endpoints with Control Center available with Cypress Suite USB 3.4.7 or EZ-USB FX3 SDK
Check this forum link, it may be useful:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I understand that you are using the FX2LP device. The bulkloop firmware can be found in the below path after the installation of CY3684 DVK.
C:\Cypress\USB\CY3684_EZ-USB_FX2LP_DVK\1.1\Firmware\Bulkloop
Best regards,
Srinath S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, I don't have the directory path.
I am working with a Cy8ckit-059 5LP Prototyping kit which has a cy8c588LTI-LP097 in it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can check the Project1 of AN56377 depicting the loopback at interrupt, bulk, and isochronous endpoints with Control Center available with Cypress Suite USB 3.4.7 or EZ-USB FX3 SDK
Check this forum link, it may be useful: