cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

roge_4738861
New Contributor

hello, 

I tried to write a simple project to see if I can use the rtc component in psoc 5lp - 059.

I attached here my project can someone please help me and tell me why the rtc data (min,sec....) stay the same.

***I used uart to see the data on my computer screen.

Thanks!

0 Likes
1 Solution
BiBi_1928986
Valued Contributor

Hello.

I haven't loaded your project (I'm running Creator 4.2 and project won't load from Creator 4.3), but I took a quick look at main.c

You should place RTC_Start() ahead of any calls to the component.  So, try placing this line of code immediately after UART_1_Start();

And, did you install a 32.768kHz crystal?  The RTC component won't work without it.

KIT-059 RTC CrystalKIT-059 RTC Crystal

Good luck with your project.

 

View solution in original post

7 Replies