cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

 i want to store fpga program file .pdb for microsemi igloo in psoc and use it how can this be done?

0 Likes
Reply
2 Replies
Esteemed Contributor II

What will the file's size be approximately?

   

How are you going to transfer the file to the PSoC (what interface etc)

   

What format is transferred to your fpga

   

Do you really need a "file" or would the bit pattern that is transferred to the fpga be sufficent

   

Why don't you use an EEProm to store the data.

   

There is an emFile component that communicates with SD_cards, so you may store the file on that card and read and transfer data with the PSoC

   

I am afraid that you should tell us a bit (or byte ) more about your complete system and what you want to perform

   

 

   

Bob

0 Likes
Reply
Esteemed Contributor

Normal programming done with bitstream per Igloo spec, SPI or JTAG,

   

yes PSOC could support that. The update of FPGA file in PSOC could be

   

done via GUI and bootloader or a proprietary interface over many optional

   

communication modes.

   

 

   

    

   

          

   

http://www.cypress.com/?rID=50230     AN68272 UART BL

   

http://www.cypress.com/?rID=41002     AN60317 I2C BL

   

http://www.cypress.com/?rID=57561     AN73503 USB HID BL with GUI Host

   

http://www.cypress.com/?rID=56014     PSoC® 3, PSoC 4, and PSoC 5LP Introduction To Bootloaders

   

 

   

 

   

Regards, Dana.

0 Likes
Reply