- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to do work with PSOC 5LP and tried to connect LCD_I2C PCF8574AT. I have no problem building a project, but at the timeof debugging using PSoC creator I got an error "ARM Debug Port" and when I tried to port acquire it was showing that "this device was recognized, but PSoC Creator does not support using at this time". Further when I again pressed the port aquire, then it was showing the target requires but revision as UNASSIGNED. Any suggesion how to fix it.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Dheeraj,
Thank you for give the your attention.
I am using the Kitprog.
But I resolved this issue just now. There was an error of updating firmware.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you post the screenshot of the port settings which you used for programming the kit? Are you using Kitprog or Miniprog 3 for programming?
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Dheeraj,
Thank you for give the your attention.
I am using the Kitprog.
But I resolved this issue just now. There was an error of updating firmware.