Attachments are accessible only for community members.
Anonymous
Not applicable
Jun 18, 2017
10:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 18, 2017
10:31 PM
I want to configure cypress mbr3116 using i2c protocols by using host controller Renesas R8C25276. The host is writing data in memory of cypress but after giving command of Save_Check_crc & Reset_sw it is going in low power state mode. I have given wake up instruction to wake up the device & The delay between two i2c transaction is also less than 320ms. Host is reading data correctly after sending commands but its not working. Is there any other parameters i need to check?
Labels
- Labels:
-
PSoC 1
0 Replies