change the configuration of the chip

[Anonymous]

Can I change the configuration of the chip during the operation?
for example: CY821434 set (ADC10_1, I2Cm_1), at run-time algorithm to disconnect  ADC10_1 and connect Cap Sensors CSD.

[ETRO_SSN583]

Yes, thru register writes. A training video -

       

http://www.cypress.com/?id=1162&tagID=2522

       

The register specifics are in Register TRM (Technical reference Manual).

       

Regards, Dana.

[ETRO_SSN583]

A word of caution, this would not be trivial as there are a number of issues

   

relating to "tuning" a cap sense design, but this should help you -

       

      http://www.cypress.com/?docID=32332

       

Regards, Dana.

[Anonymous]

Thank you very much for the information