PSoC™ 5, 3 & 1 Forum Discussions

 Hello. I am very new to the PSoc range of controllers, however i have a considerable number of years of experience on 8051/8052 and Atmel's AVR series. I read somehwere that PSoc has a modified / optimized 8051 core. Just want to know if some of you can clear me on whether the PowerPSoc 2 series has a 8051 core or is it something very different ?

Provided that the above holds true for PowerPSoc 2 having an 8051 core, is it possible to develop any applications for it using other IDEs and compilers, like Keil-C ?

The reason for my questions is that i am trying to figure out the time for teh learnign curve of PowerPSoc, since i come from a background of 8051 and AVR.

Your help and suggestions / comments are very much appreciated.

Warm Regards,

Zeeshan

Hi,

need some help to understand the port configuration of the CY8C95xxA. What I have done is to add a LED to a port pin. In default state the LED lights up. Set the output to 'Low' the LED is off. So far OK.

But when I configure the GPort as Input and Set Drive Mode to High-Z after power up, the LED still lights up. In my understanding the LED should be off.

What went wrong there? Is my  configuration wrong or didn't I understand the GPort architecture and this is a right behaviour? But if this behaviour is right, why do I have the possibility to set GPort as Input?

Thank you in advance,

Herrol

Has anyone ever interfaced a K-Type thermo couple to PSoC 3/5 ?

I'm looking for some tips on interfacing this themocouple to PSoC3 or PSoC5

Hello all,

I am new to programming of the PSoC devices.

Which is the simplest way of programming a PSoC chip without having to use additional hardware like MiniProg3 ?

Thank You

Hi
I using the CY8C21534B as I would like to creat the following:
8 cap buttons
1 proximity
8 output to reflect each button (logic)
1 output to reflect proximity result (logic)
1 output to heptic/speaker
UART for serial communication
I thought the CY8C21534B will be excellent for it but then found out that i have only 4 digital blocks.The UART need 2 block and the Smart sense need 3 digital blocks. this means that I cant do it or are dont understand how to do it?

can you help?
any recommendation?
 

Dear all,

I am thinking about buying a 001 Kit. But I am unsure, the distributors have 001A and 001B Kits.

In which Kit the PSoC 5 production silicon is available?

Thanks for your help!

Best regards,

Hello,

I have a doubt about the reconfiguration PSoC's property. I already know that the hardware of this system has the capacity of being configured as you want from the software PSoC Creator. That I don't know is what happens once you have configured the system and you are running the project in it, can you reconfigure it in terms of adding a new element as a filter or converter for example?

Another related question, can you build two different projects (different hardware configuration) in the PSoC and then when you are running the PSoC, to choose between them?

I hope I have explained.

Regards!

I need to obtain the status of a port pin of CY8C9560A after sending a value. Can I get the status by reconfiguring the same port as input and reading it?