PSoC™ 5, 3 & 1 Forum Discussions
Hi,
im using a TIA and want to gain and invert that signal with a "inverting PGA". The gain works fine, but i cant invert the signal. No matter how i connect it or using a "PGA" or a "inverting PGA", the outputsignal is always negativ. I routed the signals via GPIO to an oscilloscope to opserve them. Whats wrong?
Thanks
Show LessI am using linear slider in my project. When I call Get Centroid Position and start sliding my finger over the slider the value at a particular position varies. I have my resolution as 100. When my finger is on button 3 it varies all the way from 24-50. I dont know whats the reason for this.
Show LessI am using psoc 3 and I can't find how to initialize the eeprom with initial values. I found #pragma abs_address for psoc 1 but I can't find it for psoc 3.
Thank you.
Show LessHello,
I have a CY8kit-050 and while I have made a request for an upgrade, I've been wondering if I can't do the upgrade myself.
I haven't verified this myself yet but from what I understand the 5LP is pin compatible with the 5, so all I'd have to do is remove the "old" PSOC5 and solder a new 5LP onto my board.
From what I've seen the new CY8kit-050LP comes with the CY8C5868AXI-LP035.
Is the board of the new CY8KIT-050LP still the same just with the new 5LP chip or have there been any modifications to make the board compatible with the new chip?
Show LessIn the application note AN75511, FindHotJnuVolt() API is used in sample code given.Where do we find this API?..because in the thermocouple calc,only two APIs namely 'int32 Thermocouple_GetTemperature(int32 voltage)' and 'int32 Thermocouple_GetVoltage(int32 temperature)' are mentioned.
Show Less