PSoC 5, 3 & 1 MCU

[Anonymous]

Is a baud rate of 115200 only supported via the kitprog FW ? I am using CY8Ckit-059 and wish to use a higher baud rate for an application . like 460800 baud

I tried by changing the baud rate on the UDB in my application and did not get consistent desired results on PC terminal window

Thanks

Sreedhar

[NoriakiT_91]

The specification of the USB-UART bridge is described in the "KitProg User Guide" document as follows.

The maximum baud rate is 115200

The "KitProg User Guide" can be downloaded from a KIT web page like following.

CY8CKIT-059 PSoC® 5LP Prototyping Kit With Onboard Programmer and Debugger | Cypress Semiconductor

CY8CKIT-046 PSoC® 4 L-Series Pioneer Kit | Cypress Semiconductor

The "KitProg2 User Guide" has same specification.

The "KitProg2 User Guide" can be downloaded from a KIT web page too.

CY8CKIT-145-40XX PSoC® 4000S CapSense Prototyping Kit | Cypress Semiconductor​

There is a dedicated WEB page too.

KitProg2 User Guide | Cypress Semiconductor​

Regards,

Noriaki