Jan 05, 2021
09:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2021
09:43 PM
hi :
i get a sch from net cy8c27443 , The pin22 go to gnd by cap, but in my sch contact with a led and res to gnd
pin22 , i want to use pwm module this pin ,this connection is right? or not
Solved! Go to Solution.
Labels
1 Solution
Jan 06, 2021
03:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 06, 2021
03:17 PM
Your PWM can be routed to Port2.4 on pin 22
This pin is also used as a bypass with a cap to reduce the noise on the analog ground reference.
If you don't need that last little bit of low noise, feel free to use it as a PWM output.
---- Dennis
1 Reply
Jan 06, 2021
03:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 06, 2021
03:17 PM
Your PWM can be routed to Port2.4 on pin 22
This pin is also used as a bypass with a cap to reduce the noise on the analog ground reference.
If you don't need that last little bit of low noise, feel free to use it as a PWM output.
---- Dennis