- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i have a llight sensor Conventional design like this 5V+sensor+res+gnd
|
| CY8C27443-ADC-input
Is the method correct?
Solved! Go to Solution.
- Labels:
-
PSoC1 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, this method is correct. I assume the light sensor is resistive. You have to take care about the span of the voltage range though. Kindly review AN2219 - PSoC® 1 Selecting Analog Ground and Reference for more information.
Best regards,
Sampath Selvaraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, this method is correct. I assume the light sensor is resistive. You have to take care about the span of the voltage range though. Kindly review AN2219 - PSoC® 1 Selecting Analog Ground and Reference for more information.
Best regards,
Sampath Selvaraj