Anonymous
Not applicable
Sep 24, 2010
05:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2010
05:41 PM
Is any special handling recommended for un programmed pins on the kit board ? How does PSOC creator handle un programmed pins ?
I have a project that has pins that are for possible future use. The pins will be connected via the board connector to a back plane that supplies power and I.O. connections including connections that have not been defined. Is it better to set the pins up or not define them at all ?
Thanks
Jim
Labels
- Labels:
-
PSoC 3
1 Reply
Anonymous
Not applicable
Sep 29, 2010
07:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 29, 2010
07:46 AM
Hello Jim,
All the unused pins in PSoC will be in a high impedance state unless you configure them to operate in a particular mode.
Regards,
Udayan