Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
OK
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable
‎Sep 24, 2010 05:41 PM

Un-used pins on PSOC3 kit board

Is any special handling recommended for un programmed pins on the kit board ?    How does PSOC creator handle un programmed pins ?  

   

I have a project that has pins that are for possible future use. The pins will be connected via the board connector to a back plane that supplies power and I.O. connections including connections that have not been defined.  Is it better to set the pins up or not define them at all ?

   

Thanks

   

Jim

Labels
0 Likes
Reply
1 Reply
Anonymous
Not applicable
‎Sep 29, 2010 07:46 AM

Re: Un-used pins on PSOC3 kit board

Hello Jim,

   

All the unused pins in PSoC will be in a high impedance state unless you configure them to operate in a particular mode.

   

 

   

Regards,

   

Udayan

0 Likes
Reply