May 09, 2014
12:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 09, 2014
12:40 PM
I would like to be able to use the 5 pin programmer pins to both program and connect the tuner helper using a miniprog3. So far I have always needed to use a separate I2C port and pins to run the tuner helper. There must be a way to share that connector so that you can both program and then switch right over to the helper. Any suggestions or has anyone done this?
Labels
- Labels:
-
PSoC 3
0 Replies